Chapte
r 2: Installation
724-746-5500 l www.blackbox.com
27
Table 2.5: InvisaPC System Default Network Settings
Component
IP Address
Type
Default
Gateway
Subnet Mask
InvisaPC
Receiver
192.168.1.21 Static
0.0.0.0
255.255.255.0
InvisaPC
Transmitter
192.168.1.22 Static
0.0.0.0
255.255.255.0
1.
With the InvisaPC Transmitter already connected to the remote workstation,
connect it to the network via the unit's RJ-45 connector.
2.
Connect the InvisaPC Receiver to the peripherals. Use UTP cable to connect the
InvisaPC Receiver to the Ethernet network via the RJ-45 connector on the rear of the
InvisaPC Receiver.
3.
Turn on the InvisaPC Receiver. A default connection is available to allow connection
to a default InvisaPC Transmitter. You can use the OSD to add different connections
to remote Transmitters or virtual desktops (see Chapter 3 - Operations for details on
how to add a connection). The default Transmitter IP address is 192.168.1.22
4.
Use the OSD on the InvisaPC Receiver to reconfigure the network settings for the
InvisaPC transmitter.
NOTE:
If the InvisaPC Receiver and Transmitter are to be located on different subnets, configure their network
settings before you connect to the network.
NOTE:
If there are already InvisaPC Receiver and Transmitter pairs operating on the subnet, configure network
settings of new InvisaPC Transmitter and Receiver pairs before connecting them to the network.
5.
Repeat this procedure for each InvisaPC Transmitter and Receiver pair you wish to
install on the network.
