5
®
®
724
-74
6-55
00
®
OU
T
OU
T
OU
T
OU
T
LINK
POW
ER
SHA
RP
BRIG
HT
REC
EIV
ER
Wiza
rd
Multi
media
Exte
nder
Plus
To connect the power supply
NOTE: Please read and adhere to the electrical safety information given within
the
Safety.information
section of this guide. In particular, do not use an
unearthed power socket or extension cable.
1 Attach the output connector of the power supply to the
socket labelled
POWER
on the Wizard MultiMedia Plus
receiver.
2 Insert the IEC connector of the power cable
into the corresponding socket of the
power supply.
3 When all other connections
have been made at the
transmitter and receiver
modules, connect the other
end of the power cable to a
nearby earthed mains socket.
®
724
-74
6-55
00
®
OU
T
OU
T
OU
T
OU
T
LINK
POW
ER
SHA
RP
BRIG
HT
REC
EIV
ER
Wiza
rd
Multi
media
Exte
nder
Plus
To connect the serial port
The AVU6011A/AVU6111A receivers provide a single RS232 serial socket for use
with display control circuitry, etc. Where two connected displays both require
serial control, a special
Y-cable
is available.
Note: The Y-cable is supported only when the AVU6011A/AVU6111A receiver
is linked to an AVU6004A or AVU6008A transmitter. If the receiver is linked to
an AVU6001A transmitter, only a single display may be connected to the serial
connector of the AVU6011A/AVU6111A receiver.
1 Attach the female connector of the Y-cable or serial device link cable to the
socket labelled
on the AVU6011A/AVU6111A receiver.
2 Attach the other end of the serial cable (or both ends
of the Y-cable) to the appropriate RS232 control
socket(s) of the display(s).
Note: The two male connectors of
Y-cable are labelled A and B.
These labels are important
and identify each
display for port
switching purposes.
Important
• It is essential that the source PC, all AVU6004A/AVU6008A modules and
all connected displays are configured to use the same serial communication
settings (see
Switch.settings
for details). The AVU6001A, AVU6011A and
AVU6111A modules all auto-sense the serial configuration and do not have
switches.
• When switches SW2 to SW10 are all OFF, the module is set to expect the
following serial port configuration: 19200 baud, 8-bit data byte, 1 stop bit,
no parity checking, software handshake.
Important
Wizard MultiMedia Plus transmitters
and receivers are supplied with
power adapters which provide a
slightly different voltage to those
used with other Black Box products.
Although the Wizard MultiMedia Plus
family power adapters appear to be
physically identical, they are labelled
as
5.VDC
(rather than the usual
5VDC). Using a standard Black Box
5VDC power supply will not cause
damage but may affect operation.
