Chapter 3: Installation
724-746-5500 | blackbox.com
Page 23
From the pri-
mary video
display
From the sec-
ondary video
display (if
used)
2 If a second video display is to be used, connect its cable to the DP++ port 2 on the rear panel of the transmitter unit. If an
adaptor is required, see above.
Note: Although port 2 supports DP++ dual-mode operation, it is limited to 154Mpixels/sec (when the Wizard DP Extender
units are running in high rate mode). Some single-link video connections require up to 165Mpixels/sec.
3.2.7.3 To connect the video ports
1 Connect the DisplayPort video cable from the primary video display to the DP++ port 1 on the rear panel of the transmitter
unit.
If an adaptor is being used to convert signals, connect it to the DP++ port 1 and connect the cable from the video display to
the output of the adaptor. If an externally powered adaptor is required, you may need to also connect it to one of the USB
ports in order to derive its power.
