Black & Decker BHSM15FX08, Оригинальное руководство пользователя

Страница: 11 / 108

11
ENGLISH (Original instructions)
u
White LED is lit up to show which steam setting is being
used.
u
User can press the steam button to pause the steam flow
and the white LED goes off.
u
To switch appliance off, press the on/off switch (1).
Off
On (boiler heat up) 30 seconds
flashing
On (boiler ready)
On (High Flow)
On (Low Flow)
The steam mop will select the correct volume of steam
required for your particular cleaning operation.
Note: Always check you are using the correct setting before
using your steam mop.
Attaching the small worktop mop head
(Fig. E)
u
Push small worktop mop head (10) into the hand held
steam unit (3) making sure it clicks securely into place, as
shown in figure E.
Attaching a cleaning pad to the small worktop
mop head (Fig. F)
Replacement cleaning pads are available from your
BLACK+DECKER dealer :- (cat no. FSMP60-XJ).
u
Place a small desktop cleaning pad (18a) on the floor with
the velcro 'loop'side facing up.
u
Lightly press the small worktop mop head (10) down onto
the cleaning pad.
Caution! Never leave the steam mop in one spot on any
surface for any period of time.
Always place the small worktop mop head supported in the
upright position when stationary and make sure the hand
heldsteam mop is turned off when not in use.
Attaching the adaptor and accessories to the
hand held steam cleaner
Warning! Inspect the seal between the connection point on
the hand held steam cleaner and the adaptor (9) before
each use. If the seal malfunctions or is damaged, please
contact your nearest authorised repair agent. Do not use the
appliance.
Attaching the adaptor (Fig. G)
u
Press the adaptor release button on the adaptor (9).
u
Connect the adaptor (9) to the hand held steam
cleaner and release adaptor release button
making sure it clicks into place.
Important! Ensure that the adaptor (9) is securely
connected to the hand held steam cleaner. If steam escapes
from the joint, the adaptor is incorrectly fitted. Switch off, allow
the unit to cool then remove and refit.
Warning! The unit should be switched off before the adaptor
is fitted.
Attaching accessories 11 - 15 (Fig G, H)
u
Align the lugs on the adaptor (9) with the recesses
on the accessory.
u
Press the accessory onto the steam nozzle and twist
anticlockwise until the accessory clicks into place.
Important! All accessories must be attached to the adaptor
(9) for use.
Removing an accessory
u
Twist the accessory clockwise then pull away from the
adaptor (9).
Warning! Allow the unit and all accessories to cool before
attempting to remove.
Removing the adaptor
u
Press the adaptor release button on the adaptor (9) and
pull away from the hand held steam unit (3).
Warning! Allow the unit and all accessories to cool before
attempting to remove.
Removing the small worktop floorhead (Fig. E)
u
Push the small worktop floorhead release button (10a)
and pull away from the hand held steam unit (3).
Warning! Allow the unit and all accessories to cool before
attempting to remove.