5
English
from the air vents, especially after cleaning / replacement of the
filters as debris inside the unit can be disturbed.
• Leaks from battery cells can occur under extreme
conditions. If the liquid, which is a 20‑35% solution of
potassium hydroxide, gets on the skin (1) wash quickly with
soap and water or (2) neutralize with a mild acid such as
lemon juice or vinegar. If the liquid gets into the eyes, flush
them immediately with clean water for a minimum of
10 minutes. Seek medical attention.
ADDITIONAL SAFETY WARNINGS
a )
Prevent unintentional starting. Ensure the switch
is in the off‑position before picking up or carrying
the appliance.
Carrying the appliance with your finger
on the switch or energizing appliance that have the
switch on invites accidents.
b )
Recharge only with the charger specified by the
manufacturer.
A charger that is suitable for one type
of appliance may create a risk of fire when used with
another appliance.
c )
Do not use an appliance that is damaged or
modified.
Damaged or modified batteries may exhibit
unpredictable behavior resulting in fire, explosion or
risk of injury.
d )
Do not expose an appliance to fire or excessive
temperature.
Exposure to fire or temperature above
266 °F (130 °C) may cause explosion.
e )
Follow all charging instructions and do not
charge the battery pack or appliance outside
of the temperature range specified in the
instructions.
Charging improperly or at temperatures
outside of the specified range may damage the battery
and increase the risk of fire.
f )
Have servicing performed by a qualified repair
person using only identical replacement parts.
This
will ensure that the safety of the product is maintained.
g ) Do not modify or attempt to repair the appliance or the
battery pack except as indicated in the instructions for
use and care.
h ) Only for use with S010QU2300040 charger.
SAVE THESE INSTRUCTIONS
The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ......................... volts
Hz .......................hertz
min .....................minutes
or DC ......direct current
...................... Class I Construction
(grounded)
…/min ..............per minute
BPM ....................beats per minute
IPM .....................impacts per minute
RPM .................... revolutions per
minute
sfpm ................... surface feet per
minute
SPM ....................strokes per minute
A .........................amperes
W ........................watts
Wh ......................watt hours
Ah .......................amp hours
or AC ...........alternating current
or AC/DC .... alternating or direct
current
...................... Class II Construction
(double insulated)
no .......................no load speed
n .........................rated speed
......................earthing terminal
.....................safety alert symbol
.....................visible radiation
..................... wear respiratory
protection
..................... wear eye protection
ASSEMBLY AND ADJUSTMENTS
WARNING:
To reduce the risk of
serious personal injury, turn unit off before
making any adjustments or removing/installing
attachments or accessories.
An accidental start‑up
can cause injury.
Assembly (Fig. B)
1. Align the top of the extension tube
8
with the vacuum
inlet
14
as shown in Fig. B.
2. Push the extension tube
8
onto the vacuum inlet
14
so
it locks into position.
3. To remove an accessory, press the extension pole release
button
7
located on the vacuum inlet or the bottom
of the extension tube and gently pull the connected
accessory off.
WARNING:
When not in use position the
unit with the rear of the vacuum facing a wall so that
any inadvertent fall of the unit would contact a wall
and not people or pets.
OPERATION
WARNING:
To reduce the risk of
serious personal injury, turn unit off before
making any adjustments or removing/installing
attachments or accessories.
An accidental start‑up
can cause injury.
Charging the Battery (Fig. C)
WARNING:
Use only with the supplied
charger. From new, the rechargeable cells of the
product need a minimum charge time of 5 hours to
ensure full power.
• The unit must be turned Off in order to charge.
• Plug the jack plug
19
of the charger
12
into the
charging port
2
of the vacuum.
• Plug the charger into a standard electrical outlet.
• While charging, the charger may get warm, this is
perfectly normal and safe. It is safe to leave the appliance
connected to the charger indefinitely. The charger
automatically reduces power consumptionwhen
charging is complete.
WARNING:
Do not charge the battery
at ambient temperatures below 40 °F (4 °C) or above
104 °F (40 °C). Follow all charging instructions and do
not charge the appliance outside of the temperature
range specified in the instructions. Charging improperly
or at temperatures outside of the specified range may
damage the battery and increase risk of fire.
..................... wear hearing
protection
..................... read all
documentation
