Bitstorm Inc.
Bad Boy Xtreme
www.bitstorm.com
7
sparingly to the contacts of the device cable end connector.
Note: A thin
coating of corrosion inhibitor is all that is needed. Too thick may result
in floating connector pins and poor connections.
Put the Xtreme’s cable end
through bottom cover and plug
into Xtreme. If convenient, verify
that Power LED will light. Investi-
gate if it does not illuminate.
Screw the bottom cover on just
snug.
Note: Do not over tighten
. Seal the cable opening in the bottom cover
using the white grommet (included) which has a split (look closely for it) to
allow it to be added onto the cable. Check that the grommet is seated fully
to ensure a weather tight seal.
If cable was cut, locate the included Junc-
tion Box kit. Using the included tool, strip
back about 1 inch (2.5cm) of the outer
jacket from both cable ends. Rotate the
tool around the cable to make a clean cut.
There is no need to strip the insulation
from the individual wires. Refer to photo.
Connect the wires to the spade terminals
using the tool’s metal tip. Lay the wire
onto the spade and push down with the
tool. The spade will pierce the insulation
thus making electrical contact. Ensure that
both cables have the same colour wire
connected to the same pin number on both
left and right sides. Pin numbers may be
found on the actual block or on the cover.
If the Junction Box has wire colours shown
next to the spades, these can be used as a
guide as well. Refer to photo.
Note:
Junc-
tion Box may not be exactly as shown. A
suggested wiring order is:
1 Orange/White
5 Blue / White
2 Orange
6 Green
3 Green / White
7 Brown / White
4 Blue
8 Brown
Secure the cable into the Junction Box
using the tie wraps to prevent stress
and snap or screw the cover in place.
Connect to a power source: AC Adapt-
er or DC Power Cable. For Power Ca-
ble: red (or white stripe) is po)
and solid black is negative(-). For DC
voltage limitations, refer to your includ-
ed Power Adapter for input voltage
requirements. Observe that the green
