Mechanical
Switches
Version A.0
BitFlow, Inc.
CYT-10-3
10.3 Switches
There is one piano-type switch block, SW1, on the Cyton-CXP with two switches.
These are used to identify individual boards when there is more than one board in a
system. The idea is to set the switches differently on each board in the system. The
switch settings can be read for each board from software (by reading the SW bitfield).
SysReg also shows the switch setting for each board. See Table 10-2 below shows the
switch settings and the corresponding value in the SW bitfield.
There is one micro switch block, SW3, on the Cyton-CXP with four switches. These
used to control the flash bank that the system boots from.
Note: Do not change these switches unless instructed by BitFlow support.
See Table 10-3 below which shows the switch settings and the corresponding firm-
ware bank.
Table 10-2 Switch S1 Setting
SW1.1
SW1.2
SW register
down
down
0
down
up
1
up
down
2
up
up
3
Table 10-3 Switch S3 Setting
SW3.4
SW3.2
SW 3.2
SW 3.1
FW Bank
off
off
off
off
1
off
off
off
on
2
off
off
on
off
3
off
off
on
on
4
off
on
off
off
Reserved
off
on
off
on
Reserved
off
on
on
off
Reserved
on
on
on
on
Reserved
on
off
off
off
Reserved
on
off
off
on
Reserved
on
off
on
off
Reserved
on
off
on
on
Reserved
Содержание Cyton-CXP
