BitFlow Cyton-CXP, Справочник по аппаратуре

Страница: 348 / 388

Trigger The Cyton-CXP
CYT-9-2 BitFlow, Inc. Version A.0
9.2 Trigger
9.2.1 Trigger Input Types
There are four trigger inputs.
TRIGGER_TTL - Single ended TTL level trigger
TRIGGER_DIFF - Differential (LVDS) trigger
TRIGGER_OPTO - Optocoupled trigger
FEN - The FEN signal on the CL1 connector.
The hardware trigger is enabled/disabled by the bit EN_TRIGGER. Only one input at a
time is active (the software trigger bit, SW_TRIG, is always active). The active trigger is
selected by the bitfield SEL_TRIG. The current level of these inputs can be read from
software by reading the bits RD_TRIG_DIFF, RD_TRIG_TTL, RD_TRIG_OPTO and RD_
FEN. The unselected triggers will have no effect on the board. However, they can be
used as general purpose inputs.
9.2.2 The Optocoupled Trigger
The opto-coupled trigger allows the acquisition circuitry to accept a trigger signal
without having a galvanic connection to the trigger source. This is mandatory in some
medical and industrial application. The trigger information is passed as a light pulse
from an on-board LED that is coupled to a receiving phototransistor. The LED and the
phototransistor are in the same package, a Sharp PC3H711. Figure 9-1 shows the
electrical diagram of the optocoupled trigger circuit and a suggested circuit for the
driver. The LED is driven by an open collector driver. The user must supply his +5V
power to the LED. Note that there is no galvanic connection between the user’s circuit
and the acquisition circuitry.