w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
11
M
aintenance and care
1.
Unplug the vacuum from electrical outlet.
2.
The pre-motor filter protects the motor from
dirt particles. It is located in the slide out
tray underneath the dirt container. If the
filter becomes dirty, pull out the tray, lift
out the foam filter pad and clean it.
note: the pre-motor filter may be
hand washed in cold water with mild
detergent. Rinse well and air dry thor-
oughly before replacing.
3.
The post-motor HEPA media filter assists
in the filtration process to return clean air
to the room. It is located behind the door
on the side of the vacuum. If the filter
becomes dirty, remove the door, remove
the filter and replace.
note: the post-motor filter is
a white, pleated hepa media
filter. this filter is not washable
and must be replaced when it
becomes dirty.
You should check your vacuum cleaner’s
rotating floor brush and drive belt regularly
for wear or damage. You should also clean
the brush and brush ends of strings, hair
and carpet fibers. This type of debris can
wrap around the brush and hamper its
ability to effectively clean your carpet. Also
remove any debris that has accumulated
under the brush cover.
1.
Unplug the vacuum from electrical outlet.
2.
Place handle in low position and turn vacu-
um cleaner over so bottom side is facing up.
3.
Lift tab 1 and release the three latches in
order 2-4 marked. Lift off the brush cover.
4.
Grasp rotating floor brush at both ends and lift.
5.
Clean strings, hair and other debris from
rotating floor brush, paying particular
attention to brush ends.
6.
Clean strings, hair and other debris from
motor pulley and drive belt areas.
cleaning the pre-motor and post-motor hepa media filters
WARNING:
Do not operate cleaner with
damp or wet filters or without all
filters in place.
check rotating floor brush and drive belt
WaRning:
To reduce the risk of injury from
moving parts, turn vacuum cleaner
off and disconnect power plug
from electrical outlet.
Post-Motor
HEPA
Media
Filter
Washable
Pre-Motor
Filter
3.
1
2
3
4
