Assembly
Cont´d
END PLATES
C6200001
ASSEMBLY (OPTIONAL)
A.
Attach rear blade to tractor.
B.
Raise the blade a few inches off the ground by
operating the lift control lever of the tractor.
C.
Properly support blade on blocking while installing
end plates to prevent possible safety situation if rear
blade were to fall due to lost hydraulic pressure.
D.
Assemble the end plates (1) to the moldboard
using bolts (3), spacers (2), hex nuts (4), and lock
washers (5) making sure the holes of the end plate
line up with the holes at the edge of the moldboard
while the top and bottom edge of the end plates (1)
are flush to the top and bottom of the moldboard.
E.
Place the left and right braces (6 & 8) and secure
to the moldboard and end plates (1) using four bolts
(7), lock washers (5), and hex nuts (4).
F.
Lower the blade to the ground.
1.
2.
3.
4.
5.
6.
7.
8.
End Plate
Spacer
Bolt, 5/8 x 3 1/2 HHCS GR5
Hex Nut, 5/8
Lock Washer, 5/8
Left Brace
Bolt, 5/8 x 1 1/2 HHCS GR5
Right Brace
RB341
1
1
5
5
5
4
7
3
3
2
2
8
7
4
5
5
4
4
4
4
5
4
5
4
5
7
6
7
3
3
2
2
21
Assembly
4350-2113-00 (Rev. 09/06/04)
