16
<Using sliding supporters>
Raise supporters slightly and adjust sliding supporters to align with lifting points of the vehicle.
Manually pull out the sliding part to adjust. Set side sill blocks on supporters to align with lifting
points.
<Using swing arms>
Raising swing arms
①
Press the arm raising button (Up button) on
the operation switch with the lift unit at the
lowest position.
②
Swing arms are raised and retained at that
position.
Rotate, extend and retract swing arms to align rubber pads with lifting points and adjust the height of
each supporter so that the load is distributed evenly on each supporter.
Raise swing arms only when the lift unit is at the lowest lowered position.
* Always make sure that the rubber pads contact flat and stable locations. Lifting on slanted
and other unstable locations can result in loss of balance and the vehicle may potentially fall.
* Adjust the height of supporters to evenly distribute the load among the four supporters. The
supporter may become dislodged and the vehicle may potentially fall.
* If the arms are not raised even when the arm raising button is pressed, always press the arm
lowering button first and then conduct verification work.
Spread swing arms as widely as possible when in use.
Caution
Caution
Warning
Rotate
