INSTALLATION
TO AVOID SERIOUS PERSONAL INJURY
PROPERLY INSTALL EQUIPMENT IN ADEQUATE WORK AREA
ALWAYS
Use Qualified Technician and Electrician for Installation.
ALWAYS
Connect to
Proper
Voltage & Phase.
ALWAYS
Install Equipment in Work Area with Adequate Light and Space Away From Children
and Visitors.
ONLY
Operate on a Solid, Level, Non-Skid Surface.
NEVER
Bypass, Alter, or Modify This Equipment in Any Way From Its Original Condition.
NEVER
Operate With Tray Removed.
NEVER
Operate Without all Warning Labels Attached and Owner/Operator Manual Available to
the Operator.
UNCRATING AND SET UP
1. Read this Manual thoroughly before installation and operation.
Do not
proceed with installation and operation if
you have any questions or do not understand anything in this Manual. Contact your local Distributor, or BIRO
first.
2. Install machine on a level, solid, non-skid surface in a well-lighted work area away from children and visitors.
3. This machine is complete
except
for a knife and plate. There is a bowl shipping plug (stamped steel) placed in
the output end of the grinding bowl to retain the grinding worm during shipment.
REMOVE THE BOWL
SHIPPING PLUG AND THE GRINDING WORM.
4. After checking and making sure the power supply is correct, plug in your machine.
NEVER OPERATE
MACHINE WITHOUT TRAY INSTALLED.
5. Machine must be properly grounded. Use qualified electrician to install according to building codes.
6. A toggle switch that activates the internal on/off switch is located on the motor junction box.
7. Lift the toggle handle up to “ON” position.
CHECK THE ROTATION OF THE WORM DRIVE SHAFT
ROTATION MUST BE COUNTER-CLOCKWISE
as indicated by the rotation decal affixed to the grinding bowl.
ROTATION MUST ONLY BE CHECKED WITH THE GRINDING WORM REMOVED,
otherwise serious
irreparable damage may occur to grinding components. Push toggle handle down to “OFF” position.
3
