BIRD 4043E, Руководство по эксплуатации

Страница: 13 / 27

Power Sensor Installation
6
e. Click MENU in the top right of the display. See
Figure 5 on page 6
.
f. Select Static or DHCP.

If Static is selected, enter a unique IP address, Netmask,
Gateway.

If DHCP is selected, go to next step.
g. Click Submit.
h. Disconnect Ethernet cable from the 4043E.
Figure 5 IP Address Configuration
3. Connect a standard Ethernet cable to the LAN connector on the 4043E and
an open connector on a network switch or router.
4. Launch your web browser on a PC connected to the same network as the
4043E.
5. Enter the sensor’s newly assigned IP address in the web browsers address
box.
6. Connect sensor to RF delivery system. See
"RF Connections" on page 6
.
7. If PTT will be used, see
"PTT Connections" on page 7
.
8. See
"Sensor Operation" on page 8
for descriptions of the sensor’s User
Interface.
RF Connections
1. Disable RF power for transmission lines to be disconnected.
2. Connect combiner's RF output cable to the 4043E RF input.
3. Connect 4043E's RF output connector to the antenna cable.
4. Repeat step
1
through
3
for any additional 4043E power sensors.
WARNING
Leaking RF energy is a potential health hazard. Never attempt to connect or
disconnect equipment from the transmission line while RF power is being
applied. Severe burns, electrical shock, or death can occur.