Bioness NESS L300, Руководство пользователя

Страница: 49 / 84

42
User’s Guide
Replacing the L300 Quick Fit Electrodes
You will need to replace the L300 Quick Fit Electrodes at least every two weeks or sooner
if they become damaged.
Caution: Use only the L300 electrodes supplied by Bioness.
Caution: Do not use your L300 System without electrodes.
Caution: Do not fold or twist the L300 Quick Fit Electrode.
To replace the L300 Quick Fit Electrodes: (See Figure 8-3)
1. Turn off the Control Unit and remove the L300 FS Cuff.
2. Gently remove the used L300 Quick Fit Electrode from the L300 FS Cuff.
3. Wet the entire new L300 Quick Fit Electrode with water.
4. Remove excess water from the L300 Quick Fit Electrode with a cloth.
5. Align the orange and blue snaps on the L300 Quick Fit Electrode with the orange
and blue plug holes on the L300 FS Cuff.
6. Press firmly to snap the L300 Quick Fit Electrode into the L300 FS Cuff.
Note: Remove and re-wet the entire L300 Quick Fit Electrode every time you remove the
L300 FS Cuff from your leg for more than one hour, and after every three to four hours of
use. When wetting the L300 Quick Fit Electrode, always remove it from the L300 FS Cuff.
Note: If the L300 Quick Fit Electrode dries out, your response to the stimulation may change.
If you need to adjust stimulation intensity more often than usual, try re-wetting the electrode.
Note: Store the L300 Quick Fit Electrode where it can air dry, when not in use.