Bioness NESS L300, Руководство пользователя

Страница: 34 / 84

27
Chapter 6 - Setup Instructions
Caution: To completely disconnect the power input, the AC/DC adapter portion of the
System Charger set must be disconnected from the main power supply.
Preparing the Skin
Before putting on the L300 FS Cuff, always check your skin for signs of irritation. If any
irritation is present, do not put on the L300 FS Cuff and contact your clinician. Wait for
complete healing before using the L300 System. For optimal stimulation, the skin under
the L300 FS Cuff should be clean and healthy.
To prepare the skin:
1. Clean the skin where the electrodes will touch with a wet washcloth. If any oils or
lotions are on the skin, clean the skin with soap and water. Rinse well.
2. If necessary, trim excess body hair from the area using scissors. Do not use a razor.
A razor can irritate the skin.
Attaching the Electrodes
Caution: Use only the L300 electrodes supplied by Bioness.
Caution: Do not use your L300 System without the electrodes attached.
L300 Quick Fit Electrode
To attach the L300 Quick Fit Electrode to the L300 FS Cuff:
1. Make sure the Control Unit is turned off.
2. If the L300 Quick Fit Electrode is attached to the L300 FS Cuff gently remove it.
3. Wet the entire L300 Quick Fit Electrode with water. See Figure 6-4.
4. Remove excess water from the L300 Quick Fit Electrode with a cloth. See Figure 6-4.
5. Align the orange and blue snaps on the L300 Quick Fit Electrode with the orange
and blue plug holes on the L300 FS Cuff. See Figure 6-5
6. Press firmly to snap the L300 Quick Fit Electrode into the L300 FS Cuff. See Figure 6-5.