Biomedical Life Systems BioStim NMS2, Инструкция по эксплуатации

Страница: 13 / 31

12
6. Electrodes and Leadwires
• The "leadwires" are the 48" wires provided with your device.
• The "electrodes" are the four adhesive pads provided with your
device.
• The leadwires and electrodes should be replaced periodically.
They are consumable supplies and are not covered under the
device warranty.
• Only use accessories approved by BioMedical Life Systems, Inc.
Use of non-approved accessories may affect the performance of
the device, cause injury and void the device warranty.
• The electrodes are disposable and should be replaced routinely
when they start to lose their adhesive properties.
• Replacement electrodes and leadwires should be reordered
through the dealer who supplied the device.
6.1 Connect electrodes and lead wires
1) Make sure the device is turned off, if the device is on, press the
button labeled "On/Off" one time until the LCD display is blank.
2) Insert the leadwires into the sockets in the top of the BioStim
NMS2 device marked "Ch1 and/or Ch2". If only two electrodes are
needed, you may insert the wire into only one Ch.
3) Attach the electrodes to the leadwires following the instructions
on the electrode packaging. At least 2 electrodes from the same
channel must be placed on the body for stimulation to begin.
4) Check to ensure that no metal is exposed from the pin of the
leadwire where it connects to the electrode.
5) Attach the electrodes to the body per your physicians
instructions.