biodex 075-594, Руководство по установке

Страница: 6 / 16

6
Biodex Medical Systems, Inc. © 2017
Atomlab 500 Dose Calibrator
Connecting the Detector:
•
Open the second carton and carefully remove the Detector. Place it in the area where it will
reside.
•
Plug one end of RJ-12 Detector Cable 3 into the Interface Module as illustrated in the
circular inset at the left of Figure 4 making sure that the open port is used. Plug the other
end of the RJ-12 Cable into the Dose Calibrator/Detector as illustrated in the circular inset
at the bottom of Figure 4.
•
Connect the two sections of Cable 5 by plugging the cable into the power transformer (see
Figure 4). Place the power connector end of Cable 5 into the Interface Module as illustrated
in the circular inset at the upper left of Figure 4. Place the other end of the power cable into
the power strip.
Figure 4. Connecting Cables from Tablet to Interface Module and Power Strip.
Note: Do not apply power to the Atomlab until all of the connections have been
completed.
Note: If a printer is not being installed on the Atomlab 500, proceed to page 15.