3
SAFETY WARNINGS
SAFETY INSTRUCTIONS
• All personnel should be alerted to the potential hazards indicated by the product safety labeling on this unit.
• The following conventions are used to indicate and classify precautions in this manual and on product safety labeling. Failure to
observe precautions could result in injury to people or damage to property.
This is the safety alert symbol. It is used to alert you to potential personal injury hazards.
Obey all safety messages that follow this symbol to avoid possible injury or death.
This symbol is used to identify the need to wear
protective gloves.
!
Caution indicates a
POTENTIALLY
hazardous situation, which, if not avoided,
MAY
result in minor or moderate injury.
Caution used without the safety alert symbol
indicates a potentially hazardous situation, which,
if not avoided, may result in property damage.
Warning indicates a
POTENTIALLY
hazardous situation, which, if not avoided,
COULD
result in death or serious injury.
This symbol is used to identify an
ULTRAVIOLET LIGHT
hazard.
This symbol is used to identify an
ELECTRICAL
SHOCK
or
ELECTROCUTION
hazard.
This symbol is used to identify the need to wear
approved ultraviolet blocking eyewear.
This symbol is used to identify the need to wear approved
ultraviolet blocking face shield.
This symbol is used to identify components which must
not be disposed of in trash
Danger indicates an
IMMINENTLY
hazardous situation, which, if not avoided,
WILL
result in death or serious injury.
SAFETY LABELS
CAUTION
UV
ULTRAVIOLET
RADIATION
Protect eyes and skin from
direct and reflected radiation.
Turn off and disconnect
power before servicing.
HAZARDOUS
VOLTAGE
DANGER
!
Danger Label: Hazardous Voltage
and Ultraviolet Radiation (00-0196A1)
It is the user’s responsibility to determine and validate the
suitability of this equipment for use in the user’s system or
process.
No warranty or representation is made by the manufacturer
with respect to suitability or performance of this equipment
or to the results that may be expected from its use.
The user should periodically inspect, clean as necessary
and confirm the presence and good legibility of the product
safety labels. Contact the factory for replacement labels in
the event that any of the labels are missing or illegible.
Location of Danger Label
(00-0196A1)
To guard against injury, basic safety precautions should be observed, including the following
:
1. Read and follow
ALL
safety instructions.
2. Do not use this water purifier for other than its intended purpose as described in this manual.
3. Do not alter design or construction.
4. Do not remove any labels or devices.
5.
To prevent the risk of severe or fatal electrical shock, special precautions must be taken since
water is present near electrical equipment. Always disconnect power before performing any service or maintenance.
6.
Avoid exposure to direct or reflected germicidal ultraviolet rays. Germicidal ultraviolet rays are
harmful to the eyes and skin.
7. Intended for indoor use only. The water purifier should be protected from the elements and from temperatures below freezing.
8. Do not operate water purifier if lamp cable, lamp connection, power cord and/or plug are damaged, or if any other damage to
the water purifier is visible or suspected
9. Electrical power supplied, to the water purifier,
MUST
match power requirements listed on the water purifier.
10.
Plug the water purifier only into an approved ground fault circuit interrupt (GFCI) receptacle.
11.
Do not operate without proper electrical ground.
12. Do not exceed water purifier’s maximum rated flow capacity.
13. Do not exceed maximum operating pressure of 100 PSI.
14. Read and follow all notices and warnings on the water purifier.
15.
SAVE THESE INSTRUCTIONS.
Содержание PURE WATER PACK BIO 1.5 PWP
Страница 19: ...19 MAINTENANCE NOTES...
