Binder 9020-0213, Перевод оригинального руководства по эксплуатации, Страница: 46 / 113

UF V (E2+E2.1) 03/2013 page 46/112
5.4.4 Operating the RFID access control
In the initial state (i.e. no access card has been registered), RFID access control is inactive, i.e., you can
open the door with pushbutton “OPEN”.
Opening the door in the initial state
Initial state (green LED is lit)
RFID access control is inactive
⇒
Open the door with pushbutton “OPEN”.
Registering the master card in the Initial state
Initial state (green LED is lit)
⇒
Hold the master card in front of the RFID panel. Card registration takes place.
Normal mode (yellow LED is lit)
Registering / clearing of an individual user card
Normal mode (yellow LED is lit)
⇒
Hold the master card briefly (< 2 seconds) in front of the RFID panel.
Learning mode (yellow LED flashes)
⇒
Hold the user card in front of the RFID panel.
•
New card: card registration takes place (green LED flashes for 2 seconds)
•
Already registered card: card is cleared (red LED flashes for 2 seconds)
•
No action during 3 seconds: Learning mode is cancelled
Back to normal mode (yellow LED is lit)
Opening the door with a user card
Normal mode (yellow LED is lit)
⇒
Hold the master card in front of the RFID panel
•
Registered card: Door can be opened during 30 sec. (green LED is lit during possible opening)
•
New card: Door cannot be opened (red LED is lit for 2 seconds)
Back to normal mode (yellow LED is lit)
Clearing all user cards
Normal mode (yellow LED is lit)
⇒
Hold the master card briefly (< 2 seconds) in front of the RFID panel.
Learning mode (yellow LED flashes)
⇒
Hold the master card > 3 seconds in front of the RFID panel.
Clearing mode (red LED is lit for 2 seconds)
⇒
Hold the master card within 2 seconds again in front of the RFID panel: All user cards are being de-
leted (red LED flashes)
•
Master card not held again within 2 seconds in front of the RFID panel: Clearing mode is can-
celled
Back to normal mode (yellow LED is lit)