Binatone CEJ-3500, Инструкция по эксплуатации

Страница: 5 / 30

5
ENGLISH
IMPORTANT SAFETY
MEASURES
Make sure that the water level is between the mini-
mum and maximum level before turning the kettle
on. Do not overfill the kettle; otherwise it can over-
flow while boiling. Please, remember that the mini-
mum water level should be higher than the mini-
mum allowed level.
Do not touch the hot surfaces of the appliance.
Do not touch the outer surfaces of the kettle with the exception of
the heat insulated handle, when water is boiling or with hot water
inside the device.
Allow kettle to cool prior to cleaning and storing.
Disconnect the appliance from the electricity supply before stor-
age, filling it with water/emptying it or moving it from one place
to another.
The appliance should always be placed on and used on a heat
resistant, horizontal and dry surface.
To avoid being burnt by hot vapor always close the lid tightly be-
fore use. Avoid exposure to hot vapor.
WARNING! Never open
the lid immediately before or after boiling temperature
is reached.
The kettle is protected against overheating and if switched on with-
out water, an automatic safety cut out device will switch it off. If
the safety device is activated, allow the kettle to cool down prior
to boiling water in it. The kettle will not switch on if it’s too hot.
WARNING! Frequent switching the kettle on without
water might result in the safety device failure, that is why
prior to switching the kettle on always check the water
level. Always make sure the water level in the kettle is
not too low.
Always switch the kettle off prior to lifting it from the base.
Use the kettle only with the supplied base.
Do not fill a hot kettle with cold water or vice versa. WARNING!
Avoid sharp temperature fluctuations when filling the
kettle with water.
Connect the device only to an electrical supply with a protective
earthing. If your socket has no protective earthing, contact a quali-
fied specialist. Do not modify the plug and do not use cord adapt-
ers.
WARNING! Electric shocks might occur if the kettle is
plugged into an unearthed power supply.
Clean the heating element of the kettle often to de-scale it. Re-
member that use of a heavily scaled kettle might result in its mal-
function.
WARNING! De-scale the kettle using only spe-
cially designed cleaning agents.
Before turning the kettle on, make sure that the lid is closed; other-
wise the kettle will not turn off after boiling.
After use of the appliance, the base of the kettle might be wet. It is
a normal condition of operation, caused by escaping steam, used
to activate the kettle’s automatic turning off function.
Do not tilt the filled kettle backwards, since water can spill through
the steam vent. If this happens, the kettle should be wiped before
turning it on.