Billyoh Mia 19351, Руководство по сборке

Страница: 8 / 15

Tools
Step
6
Continue adding the floor board (internally) making
sure to interlock each board. Do NOT secure these
boards until the last board has been measured and
cut.
Tools
Step
5
Place the first floor board inside the building flush to
the log board on one side. Fix the first board in place
using 30mm nails.
Tools
Step
7
To fix the last floor board. Measure the gap between
the bottom of the tongue (on the last board placed)
and the log board. Using a straight edge mark out the
measurement onto the last board and cut to fit.
Tools
Step
9
Once you have assembled the floor, slide the assembled
window frame over the boards, resting the frame on top of
the log board. Ensure this is level and is sitting straight. The
middle support may or may not be pre attached, if not it will
be attached later.
Tools
Step
8
Following the same method as shown in stages 5, 6
and 7 continue to affix the floor boards for the
opposite side of the cabin. Note: Review your
technical document to check floor board lengths.
Tools
Step
4
Build up the cabin wall boards another 4 layers,
ensuring you complete each layer. Use a mallet and a
spare piece of packing wood to make sure all of the
boards are flush, level and fully inserted.