103
IPSec Connection Setting
Connection Name:
A
given name for the connection (e.g. “connection to office”).
Active:
Select
Yes
to activate the tunnel.
Interface:
Select the set used interface for the IPSec connection, when you select 3G/4G-LTE
interface, the IPSec tunnel would via this interface to connect to the remote peer.
Remote Gateway IP:
The WAN IP address of the remote VPN gateway that is to be connected,
establishing a VPN tunnel.
Local Access Range:
Set the IP address or subnet of the local network.
Single IP:
The IP address of the local host, for establishing an IPSec connection between a
security gateway and a host (
network-to-host
).
Subnet:
The subnet of the local network, for establishing an IPSec tunnel between a pair of
security gateways (
network-to-network
)
Remote Access Range:
Set the IP address or subnet of the remote network.
Single IP:
The IP address of the local host, for establishing an IPSec connection between a
security gateway and a host (network-to-host). If the remote peer is a host, select Single
Address.
Содержание M500
