79
Interface or the HTTP. A password is a character string that starts with a letter and contains at least 6 and
up to a total of 15 alphanumeric characters. The password is case sensitive. The default factory setting is
“password”.
If you forget the password, the only way to recover is clear the entire configuration and return the unit to
its original state as shipped from the factory. Unfortunately, this means that you have to re-enter all of
your configuration data.
To clear the configuration and restore the password to the default, follow these steps:
Connect a console to the Console port.
Turn off the router, then turn it on again. In the console window, you’ll see the message “Loading
firmware...”
When you see the message "Ready",
immediately
(within one second) press Control-C.
The router will now reset. When this is complete, the router will return all settings to the factory default.
The password will once again be “password”.
Example:
Router> change password
Please enter the old password:
Please enter the new password:
Please re-enter the new password:
clear config
Description:
This command is used to clear the configuration data in the flash memory. After clearing,
the system will reboot. All user-configured data are lost. The configuration will return to the factory
default settings.
disable remote-mgt
enable remote-mgt
Description:
This command allows the administrator to lock out or enable both HTTP and telnet
management connections. Only a direct console connection is supported if remote management is
disabled.
disconnect telnet session <1-5>
Description:
This command disconnects an existing telnet session. This command is only valid in
Console port.
Example:
Router> disconnect telnet session 1
download config <fileName> from <ipAddr>
Description:
This command causes configuration file
router.cfg
to be downloaded to the system from a
tftp server with the specified IP address.
Example:
