Bilanciai BTEK BS-FECD-P-CPD-M, Руководство по установке

Страница: 13 / 26

2016 www.B-TEK.com Pit Type Truck Scale Installation Manual 13
Verify that all four dummy stands are inserted concentrically in the mounting plate thru holes with no binding
and that the bridge rests flat on top of the dummy cell pin.
LOAD CELL / DUMMY STAND ALIGNMENT
Once the first end module is in place on the dummy stands take a measurement from the end of the module’s
main beam to the pit’s end wall. This measurement should be 1-1/4”. Take this measurement from both main
beams to the pit wall to ensure that the distance is the same and that the module is parallel with the end wall.
The measurements should be within 1/8” of each other. If they are not, adjust the module by leveraging a pry
bar between the module and end wall to achieve squareness.
The end modules are shipped from the factory with the end bumpers and 3/8” thick backing plates installed. If
additional bumper thickness is needed, additional 1/4” and 1/8” bumper shims are shipped loose and can be
installed behind the poly block bumpers.
Final adjustments to the bumpers can be made once all of the modules have been installed and connected to
one another.