Bike-Lift HQL 400, Руководство по эксплуатации и обслуживанию

Страница: 12 / 35

Operating manual No. 057-2-6-0012-R0 Page 12
Version 2021
EN
2.4 Intended use and reasonably foreseeable misuse
Disseminate the instructions described in this chapter to all personnel involved in
the preparation and use of the machine.
- HQL400 machine is intended for lifting motorcycles, custom motorcycles and quads for
maintenance purposes
The machine has been designed and built for the specified use; a different use and non-
compliance with the technical parameters set by the Manufacturer may be dangerous
for the operators.
It can be used in the mechanical motorcycles repair shops both for the mechanical part and for the
bodywork.
Any other use different from the one indicated is to be considered as not planned and
may cause damage to the machine and Operators. It is therefore
FORBIDDEN .
The machine must always be operated by only one Operator.
The Operator must always work in proper lighting conditions and wear clothes and protections
appropriate to the task performed (typical activity of mechanical workshop)
The working position of the operator during the ascent and descent phases is closed to the
machine, paying attention to the up/down phases.
Do not try to lift motor vehicles weighing more than the maximum capacity of
the platform.
Do not try to lift four-wheeled vehicles, using two lifting platforms placed side
by side.
Do not operate on the motorcycle when the vehicle is on the work surface of the
lifting platform.