Big Dutchman Dry Rapid DR 1500, Монтаж и эксплуатация

Страница: 104 / 185

Page 94
Feed pipe
DR 1500
Edition: 08/10 M 4021 GB
6. Assemble all tubes in the house, starting at the drive. Make sure that the inner weld
seam lies on the upper side.
7. Connect the tubes to the couplers. For this, the pipe ends have to meet exactly in
the middle of the coupler, make sure that they are not caved in.
Figure 10-21: Installation of the coupler
8. Remore the lid of the corners and insert the corner wheels according to the
conveying direction.
Figure 10-22: Installation direction of the corner wheel
9. Push the tubes up to the limit stop into the corners and fasten them.
DANGER OF INJURY !
Always wear safety gloves and goggles when working with the
abrasive cutting-off machine.
For short tube segments you have to cut the tube straight and
rectangular to the tube axis. Thus, you avoid the tube being pushed
too deep into the corners.
The carrier plates of the conveyor chain / rope might get caught at
messy cutting edges when the system is in operation, which might
lead to damages at the conveyor system. Thus, make sure to burr the
tube thoroughly.