33
32
EN
EN
1
2
5. Using the appliance for the first time
6. Dispensing coffee/tea/infusions
• Unwind the power cord (7).
• Hold the water reservoir (5) from
the groove at the bottom and lift it
to remove it from its housing; top
it up with water (up to MAX) and
place it back in its housing.
• Make sure that the capsule insertion
door (1) is closed.
• Make sure that the used capsule
drawer (3) is inserted properly.
• Connect the power cord (7) to the
electric mains (Fig.2).
• Set the on/off switch (6), located on
the rear of the product, to ON.
The coffee maker will turn on emitting a beep and initialise the brew unit. Du-
ring this stage, the brew unit is closed and opened automatically to ensure the
absence of anomalies and expel any capsules inside from previous dispensing
interrupted unexpectedly (e.g. power shortage, or turning the machine off pres-
sing the on/off power). During this stage, the touch-sensitive button LED will
turn red.
In the event that the door is not closed properly, the system will not run the
verification cycle and the touch-sensitive button LED will blink red and green,
alternately.
Upon completing the verifi cation cycle, the coffee maker will start warming up
the heating unit and the touch-sensitive button LED will blink red. This stage
lasts between 25 and 35 seconds.
Upon reaching the operating temperature, the touch-sensitive button LED will
turn steady green.
The coffee maker is ready to dispense your first coffee.
• Place the cup on the plate (4) (Fig.3)
• Insert the capsule through the door (1) (Fig.4).
• Make sure to insert the capsule properly.
• Close the door. The machine will start closing the brew unit automatically and
dispensing coffee (be careful, the dispensing coffee quantity shall be 30ml only).
During this stage the touch-sensitive button LED will blink green.
• Touch the touch-sensitive button again to stop dispensing after dispensing
30ml coffee. The touch-sensitive button LED will return steady green.
• The dispensing unit opens automatically releasing the capsule in the drawer
(3).
• Do not open the door or remove the capsule drawer while coffee maker is di-
spensing coffee or expelling the capsule. This would get the capsule stuck inside
the unit and could damage the coffee maker.
IF YOU TOUCH THE TOUCH-SENSITIVE BUTTON DURING THE HEATING STAGE OR
WHEN THE CAPSULE DRAWER IS OUT OF ITS HOUSING, THE COFFEE MAKER WILL
EMIT A BEEP BUT WILL NOT DISPENSE ANY COFFEE, IN SPITE OF THE GREEN LIGHT.
REPEAT THIS CYCLE EVERY TIME THAT THE APPLIANCE HAS BEEN LEFT UNUSED
FOR A LONG PERIOD.
3
4
NOISE WHILE DISPENSING IS ABSOLUTELY NORMAL, AND IT IS DUE TO THE MECHA-
NICAL SYSTEM CONTROLLING THE DISPENSING UNIT FUNCTIONING.
5
THE TOUCH-SENSITIVE BUTTON IS
SENSITIVE TO COMMANDS ONLY IN
ITS CENTRAL PART (WHERE THE CUP
IS DRAWN). IT BEEPS EVERY TIME IT
IS TOUCHED AND RECEIVES A COMMAND
(FIG.5).
