BH FITNESS SK-9900, Руководство пользователя

Страница: 8 / 35

Page 7
BH Fitness SK9900
ASSEMBLY GUIDE
IMPORTANT:
The exercise machine is heavy. At least two people are required to ensure the safety of
those that are unpacking, installing and moving the equipment.
NOTE: For safety, maintain a minimum clearance around the equipment. Maintain 18 inches
on the front and each side plus 24 inches at the rear of the unit.
NOTE: Position on a level floor near a 110-120V electrical outlet.
1. ASSEMBLY INSTRUCTIONS
Figure 1. Take the unit out of the box and place it on the floor as shown in Figure 1. Verify
that the parts are undamaged and quantities are correct.
2. ATTACH THE MAIN POST
Figure 2. Take the post (A) and bring it up to the boss on the main body (B).
Connect the terminals (O), sticking out of the bottom of post (A), with terminal (P) coming
up out of the top of the tube on the main body (B).
Connect the terminals (R), sticking out of the bottom of post (A), with terminal (S) coming
up out of the top of the tube on the main body (B).
Slip the main post (A) over the boss on the main body (B), making sure not to damage any
of the cables.
Figure 2A. Loosely fasten using flat washers (F), Grower spring washers (G) and screws
(H). Do not fully tightening.
Check that the cables are connected correctly by spinning the pedals until the monitor
starts to operate.
Once the monitor operates, tighten the screws securely.
3. INSTALL THE BACKREST
Figure 2. Insert the backrest (E) into the tube on the seat.
Fasten using flat washers (LL), grower washers (L) and screws (K).
4. FIT THE FRONT TRIM COVER
Figure 3. Fit the front trim cover (C) by sliding it onto the side tubes. Install and tighten
screw (I) to secure the cover.