BH FITNESS SK-9000, Руководство пользователя

Страница: 9 / 43

BH Fitness SK9000B
Page 8
ASSEMBLY GUIDE
NOTE : The exercise bike is heavy. At least two people are required to ensure the safety of the
people unpacking and moving the bike.
1.
CHECK THE PARTS
Figure 1. Take the unit out of the box. Verify that the parts are undamaged and quantities are
correct.
2.
ATTACH THE MAIN POST
Figure 2. Bring the main post (A) up to the boss on the main body (B). Connect the terminals
(m), sticking out of the bottom of the post, with terminal (n) coming up out of the top of the tube
on the main body (B).
Figure 2. Slip the main post (A) over the boss on the main body (B), making sure not to
damage any of the cables.
Check that the cables are connected correctly by turning the pedals until the monitor starts to
operate.
Install the flat washers (F), Grower washer (G) and bolt (H) in four places.
Line the main post (A) up with the main body (B) and tighten the bolt securely.
3.
FIT THE FRONT TRIM COVER AND BOTTLE HOLDER.
Figure 3. Fit the front trim cover (C) by sliding it onto the side tubes. Install and tighten screw
(I) to secure the cover.
Figure 3. Remove the screws from the main post (B). Position the bottle holder and secure it
by using the screws previously removed.
4.
FIT THE TOP TRIM COVER.
Figure 4. Position the top trim cover (D) on top of the side tubes. Slide the cover forward,
inserting it into the slots on the main body (B) then position it onto the seat post.
5.
FIT THE REAR TRIM COVER
Figure 5. Position the rear cover (E) onto the saddle post, as shown in the direction of the
arrow. Fasten the rear cover (E) to the top trim cover (D) and the seat post using screws (J).