BGU FSW 5.5 H Evolution, Оригинальное руководство пользователя

Страница: 17 / 32

17
Trouble description Possible origins Remedies
No winch response when
pressing the buttons or
engaging the plug of the
control panel or the radio
control • The winch drives are damaged
• No power available
• Control valve out of service
• Check the winch drives (the driveline
must be duly connected for the pump to
operate) and ensure that there is enough
oil in the tank
• Check the power connections (plug on
the tractor, side lights ON)
• Check the batteries of your radio control
and make sure they‘re not rusty. If nee-
ded clean them.
• If power is missing, remove cause of
the blackout
• if the control valve is temporarily out of
use, try concurrent activation of the but-
tons on the control panel und the pressu-
re pads located in the middle of the ma-
gnets front side. If the problem is just a
temporary jamming, this will release the
valve.
Winch is not pulling
enough • Too much rope on the drum
• Oil on clutch discs due to bad
lubrication of the drivechain
• Clutch lining worn out
• Winch drives are damaged
• Insufficient oil pressure
• Clean or change the clutch lining
• Replace the clutch discs
• Replace damaged parts
Oil pressure lower than
145 bar • Not enough oil in the tank • Check the oil level and touch-up if nee-
ded. Seal all leaking points.
Oil pressure insufficient • The pump is damages
• Wrong setting of the pressure
switch or safety valve • Ask for service
• Ask for service
The operating pressure
drops very rapidly although
the winch is not in use • Damaged non-return valve,
pressure relief valve, control
valve or pressure accumulator • Ask for service
Brake is not holding • Wrong brake regulation
• Grease on the brake band lining
• Damaged brake mechanismus
• Worn-out brake band (collar) • Adjust brake force
• Clean the brake lining and the brake
surface on the drum
• Replace damaged parts
• Replace brake collar
5.9 Troubleshooting