BGS technic BGS 6829, Инструкция по эксплуатации

Страница: 5 / 13

BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
RECOMMENDED AIR SUPPLY
No. Description No. Description
1 Air Tool 6 De-Watering / Filter Unit
2 Air Hose 7 De-Watering Valve
3 Quick Coupler 8 Shut-Off Valve
4 Oiler (only required for air tools with motor) 9 Dryer / Filter Unit
5 Pressure Regulator 10 Compressor / 11 De-Watering Valve
OPERATION
Oil tool before each use 4 to 5 drops of a good grade Air Tool Oil placed in the air inlet is sufficient. Use
proper air pressure and CFM rating listed for this tool.
1. To set the tool to desired torque, select a nut or screw of known tightness of the same size, thread
pitch and thread condition as those on the job.
2. Turn air regulator to low position, apply wrench to nut and gradually increase power (turn regulator to
admit more air) until nut moves slightly in the direction it was originally set. The tool is now set to
duplicate that tightness
. All bolts must always be checked with a torque wrench after installation.
3. Do not tighten nuts or screws with higher torque than allowed. Put nut or screw in the thread and start
attach several revolutions by hand. With the impact wrench tighten the screw until it rests flush against
the supporting surface.
LUBRICATION & MAINTENACE
Oil tool before each use. 4 to 5 drops Air Tool Oil placed in the air inlet is sufficient.
Use proper air pressure and CFM rating listed for this tool.