5
OUT OF WALL INSTALLATION (NOT RECESSED):
1. Use a drill to drill the holes for mounting
the bracket. Use an 8 mm drill bit for drilling.
The depth of the holes must be at least 26 mm
deep. Do not use a smaller mounting size!
2. Insert the included anchors into the holes
until they line up with the plane of the wall.
3. Using a screwdriver, screw in the screws so that
their heads are 3-4 mm from the plane of the wall.
4. Hook the fireplace on the screws and make
sure it fits snugly and accurately. If necessary,
adjust the position of the screws to secure the
fireplace to the wall.
5. Remove the front glass panel. Remove the
screws on both sides of the device. You will find
these screws in the middle of the housing, screw
number 4 down from the top of the housing.
Attention! The front of the device is made
of glass! Handle with care! Shattered
glass can cause cutting injuries! Place the
glass on a clean, soft surface.
6. Be careful not to break the device cable, or
touch a sharp surface. Do not allow the cable to
come into contact with the housing, as it may
overheat during use.
7. Place the wood decoration or, if required, the supplied “crystals” in the combustion chamber and arrange them according to your taste.
8. Ask for help to replace the glass faceplate. Use the fixing screws on each side of the device to reattach the front panel.
9. Make sure the device is turned off. Connect the mains plug of the appliance to the mains socket. The device beeps to indicate that it
is ready for operation.
HOW TO USE THE DEVICE:
There are two ways to control the fireplace:
1. By using the touch screen ont he panel
2. By using the remote
The icons on the fireplace touch screen and the remote serve the same functions.
When controlling the fireplace, please note that it takes a few seconds for the control unit to receive the given instruction and process it.
On/off switch:
Press the button
on the touch panel or remote control and you will hear a short signal, the electric fireplace will
turn on, the power icon will turn blue and the other buttons will light white, the display will show the room temperature.
Device shutdown:
Press the POWER button
on the touch panel or remote control and you will hear a short signal, the light will
go out and the fireplace, including the heating, will turn off. The POWER indicator will light up in red on both the unit and the remote
control, the fan inside the unit will operate for another 10 seconds after the power is turned off, then the fireplace will enter standby mode.