4
ATTENTION!
The radiator does not include a device to control the temperature of the rooms. Do not use it unattended in a room with people who
cannot leave.
ATTENTION!
Leave at least 100 cm free space above the radiator and 200 cm in front of the radiator. Never use the radiator in a room with flammable,
explosive oil, gasoline or gas.
INSTALLATION INSTRUCTIONS:
During installation, the location of the appliance must be located in such a way that it does not come into contact with moisture or heat
pipes, gas pipes or electrical cables in its immediate vicinity. Install the appliance at least 30 cm high on the wall, so that the distance
between the ceiling and the appliance is at least 100 cm. We recommend placing the lower part of the appliance at a height of 60 cm
from the ground to ensure the best visual experience in the fireplace flag fire.
RECCESSED INSTALLATION:
The included mounting accessories allow flush mounting on drywall and wood. Prior to installation, make sure that the wall
section has the correct load capacity and can provide the power supply for the device in the given location. When fixing to a
wooden surface, it is not necessary to pre-drill the holes and use anchors for the screws!
W
85 cm
H
48 cm
1. Select the wall where you want to place the appliance, then cut a
hole of the right size for the appliance as shown! Use a spirit level
and a pencil to mark the hole. Saw with the right blade for cutting,
depending on the material.
2. Remove the glass front of the device. Remove
the screws on both sides of the device. You will find
these screws in the middle of the housing, screw
number 4 down from the top of the housing.
Attention! The front of the device is made
of glass! Handle with care! Shattered
glass can cause cutting injuries! Place the
glass on a clean, soft surface.
3. Insert the device into the previously cut hole
and mark the location of the 4 fixing points.
Remove the device. When fixing to drywall,
drill the holes and insert the drywall anchors
into the holes.
4. Insert the fireplace into the prepared hole and secure it with the 4 screws. Be careful not to break the cord of the machine, do not
break the cord, or touch a sharp surface. Do not allow the cable to come in contact with the housing, as it may become hot during use.
5. Place the wood decoration or, if required, the supplied “crystals” in the combustion chamber and arrange them according to your taste.
6. Ask for help to replace the front panel. Use the fixing screws on both sides of the appliance to fix the front panel back to the fireplace
housing (at the plane of the wall, you can do this from the side).
7. Make sure the device is turned off. Connect the mains plug of the appliance to the mains socket. The device beeps to indicate that it
is ready for operation.