BETCO STEALTH DRS24BT, Руководство оператора и каталог запасных частей

Страница: 9 / 64

9
10. MOUNTING THE PAD DRIVER
A. Connect the battery connector.
B. Turn the key to the ON position.
C. Use the switch to raise the brush deck.
D. Turn the key to the OFF position and remove it from the key switch.
WARNING: Mounting the brush with the power on could lead to
injury.
E. With the brush deck raised, place the pad driver in the shroud of the brush
deck. Turn the machine on and lower the brush deck. Turn on the brush
motor and slightly depress the speed control speed pedal. The brush motor
will begin to rotate and the pad driver with automatically attach to the brush
motor.
WARNING: This must be done wearing gloves to protect the hands.
11. THE SOLUTION TANK AND RECOVERY TANK
Fill the solution tank with clean water no hotter than 120° F (50° C), and then
add liquid detergent at a concentration specifi ed by the manufacturer. To avoid
the formation of excessive foam which would damage the vacuum motor, use
the minimum amount of detergent. Make sure the vacuum unit is lowered and
correctly positioned. Make sure the latches locking the vacuum unit to the ma-
chine are both closed and that the cap on the tank drain hose is closed.
WARNING: Always use low foam detergent. To avoid foam produc-
tion, before starting work add a small amount of defoamer liquid
to the recovery tank. Do not use acids in the pure state.
12. CONNECTING THE DRIVE MOTOR
Remove the center guard; connect the power supply wires to the reduction gear
wires as shown on the sheet provided.
WARNING: This must be done by qualifi ed personnel only. Faulty
connection of the connector wires could cause machine malfunc-
tion.
MACHINE PREPARATION