BETCO STEALTH DRS24BT, Руководство оператора и каталог запасных частей

Страница: 15 / 64

15
1. REPLACING THE SQUEEGEE BLADES
If the rear squeegee blade is worn and does not dry effi ciently, the wiping edge can
be changed as follows:
A. Remove the squeegee from the machine
B. Remove the locking latch
C. Remove the band clamps and squeegee blade
D. Turn the squeegee blade or replace if necessary
E. Replace the assembly following the same process in reverse.
F. Adjust the height of the squeegee shoe to the blade
If the front squeegee blade is worn, the vacuum will not be effective and the machine
will not dry correctly. In this case, replace as follows:
A. Remove the squeegee from the machine
B. Loosen the screws holding the front blade retainer and blade in place
C. Remove the blade and replace it
D. Replace the assembly following the same process in reverse.
2. ADJUSTING AND REPLACING THE BRUSH DECK SPLASHGUARDS
The height of the brush deck splashguards must be adjusted regularly. This must be
done with the brush deck lowered.
A. Loosen the knobs holding the guards (1)
B. Position the guards
C. Tighten the knobs
Please note that the splashguard must touch the fl oor and be parallel to the fl oor.
Check the state of wear of the brush deck splashguards regularly. If necessary,
replace as follows:
A. Unscrew the knobs to remove the guards
B. Unscrew the rubber splashguard retainers
C. Remove the splashguards and replace
Replace the assembly following the same process in reverse.
3. CLEANING THE VACUUM HOSE
If suction is inadequate, ensure that the vacuum hose is not blocked. If necessary,
clean with water introduced from the tank end of the hose. Proceed as follows:
1. Detach the vacuum hose from the vacuum coupling
2. Clean with water introduced from the tank end of the hose
3. Replace the assembly following the same process in reverse.
WARNING: This must be done wearing gloves to protect from contact
with dangerous solutions.
WEEKLY MAINTENANCE