BETCO Lil Bertha XSM 24, Руководство оператора

Страница: 5 / 32

5
TANK USE AND STORAGE
Propane Tank Use
We use the Worthington gas cylinders designed for vapor withdrawal. The fuel lock offs, regulators, and engines are
also designed for vapor withdrawal.
• We recommend that you use the OPD (Overfl ow Protection Device) vapor withdrawal type cylinder. These style
tanks have a triangle shaped valve handle.
• Do not overfi ll - the best gauge is a scale - never allow tank to weigh over 36 pounds for an aluminum tank and
43 pounds for a steel tank.
• Connect fuel cylinder to machine in a well ventilated place.
• Be aware of possible leaks of propane gas if odor is present.
• Use propane tanks designed for vertical use only.
• New tanks must be purged of air at fi rst fi lling.
Propane Tank Storage
• Store tanks outside in a well-ventilated area.
• Never store fuel cylinders in a vehicle, building, or area where they may exposed to high temperature.
• If the machine is stored inside a building, remove the fuel cylinder and store properly outside.
• Secure fuel cylinders when being transported.
• If tank is left attached to the machine then valve should be OFF.
• Store tanks in the upright position (valves up).
• Be aware of possible leaks of propane gas if odor is present.
STARTING AND STOPPING
THE HONDA ENGINE
Starting The Honda Engine
The Honda engine is equipped with a 110 volt starter and a push button start.
1. Place propane tank into handle assembly and close propane tank strap clamp to secure tank.
2. Attach propane hose coupling and fully tighten.
3. Tilt machine back so that pad is off the fl oor.
4. Open propane tank valve (turn counterclockwise) and check for any leaks.
5. Plug cord into starter connection and plug into wall outlet.
6. Push and hold throttle cable in the "Choke" position.
7. Push the red start button and hold until engine starts. Do not crank for more than 20 seconds at one time.
Wait at least one minute between tries when cranking. See troubleshooting guide if the engine does not start
after several tries.
8. After engine starts, set throttle to a slow operating speed until the motor warms up. Engine speed may be
increased after 3 to 5 minutes.
9. Unplug the cord from the wall and the machine and return the cord to its storage position.
10. Check for frost on the regulator and fuel line. Frost will indicate that the machine is drawing liquid propane
from an overfi lled or incorrect tank.
Stopping The Honda Engine
1. Turn propane tank valve to the closed position (turn clockwise) and allow the engine to continue running until
it runs out of fuel.
2. Pull throttle all the way back to "STOP" position.