BETCO GS15, Руководство пользователя, Страница: 12 / 21

16.0 PRACTICAL ADVICE FOR USE
1) With very dirty floors or floors which are particularly difficult to clean, the following washing and drying
operations can be performed:
Pre-washing: switch on the main (1), brush (5) and water pump (7) switches, but not the suction motor
one. Keep the machine within a particularly dirty area until it is clean.
Washing: spread a sufficient quantity of the cleaning solution onto the floor, switch off the water pump (7)
and continue brushing, so that the solution can dissolve the dirt which will be thus removed by the brush.
Drying: switch on the suction motor (6) and pass over the previously washed strip.
2) Simultaneous washing and drying: switch on the brush (5), water pump (7) and suction motors
simultaneously.
3) Do not keep the machine still when its brush is spinning.
4) Stop the supply of solution a few yards before changing direction.
5) To complete drying, switch on the brush and suction motors and switch off the water pump (7).
6) If the detergent solution stops flowing, the detergent solution tank is likely to be empty.
If you want to continue washing, the water pump (7) must be switched off, in order to prevent it running
dry.
7) To guarantee effective operation of the machine, nonfoaming detergents must be used.
17.0 MAINTENANCE
17.1 GENERAL INFORMATION
Carry out periodic maintenance as described below:
Daily: Check that both tanks are perfectly clean before putting the machine away after use.
Make sure the solution tank filter is clean.
Weekly: Check that the lips of the rubber squeegees are in perfect condition. Make sure the openings of
wiper blade supports are not clogged so that the solution can be completely removed from the
floor.
Every six months: Have the electrical system checked by a qualified person.
Thoroughly wash the tanks and filter.
To do this, pour 2 quarts of a solution of 90% water, 10% decalcifying detergent into the
fresh water tank and activate the pump until the tank has been completely emptied.
Rinse the tank with 1 quart of water, activating the pump until the tank is empty.
Do not carry out any of these procedures with the power supply cord plugged in.
17.2 CLEANING THE WATER FILTER
The filter can be removed without removing the rubber strip and washed carefully under running water.
Replace the filter with care.
11
!
NOTE