13
22. BRUSH COVER ASSEMBLY
The brush cover assemblies will need to be installed prior to using the machine.
Make sure the parking brake is engaged and the key switch is turned to OFF.
Remove the 8 bolts from the brush deck, there are 4 on each side. Position the
brush cover over the deck on the left and right sides of the machine and secure
them with the 8 bolts that were previously removed.
23. PAD DRIVER/BRUSH INSTALLATION
1. Make sure the parking brake is engaged and the key switch is turned to OFF
2. Connect the battery pack to the machine
3. Turn the key to the ON position and the brush deck will automatically raise to
the up position.
4. Turn the key to the OFF position and remove it from the control panel
5. With the base in the up position, insert the brushes into the plate housing be-
neath the base, turning them until the three lugs enter the holes in the brush
drive plate.
6. Once the lugs are positioned, turn the brush until the lug is locked into place
by the coupling spring. The image to the right shows the rotation direction to
lock in the right side brush. The rotation is opposite for the left side brush.
If using brushes on this machine, it is advised to rotate the left and right side
brushes every day. However, if the brushes have not been rotated for a lengthy
period of time and have deformed bristles, it is advised to reassemble them in
the same position to prevent an overload on the brush motor as well as exces-
sive vibration.
24. LOCKING HEAD PRESSURE
The pressure on the brushes can be increased by locking the pedal into place
under the seat. Press the pedal downward and to the left to double the amount
of scrubbing head pressure. To release the pressure and return to the original
scrubbing mode, press the pedal down and to the right.
WARNING: The pedal must be released and unlocked before lifting
the base into transport mode.
The pressure must be chosen according to the type of floor and amount of dirt
and soil to be removed. Increasing the pressure will cause greater wear on the
brushes or pads and will reduce the runtime of the machine.
MACHINE PREPARATION
