Beta Three TQ-22, Справочное руководство

Страница: 35 / 64

UG-TQ22-EN (V2.2-211226) - 27 -
TQ-22
Mixer Reference
manua
2.3. Route assignment operation
TQ-22 has a very powerful and flexible routing function to achieve any input to any output routing
control. Before the routing operation starts, please make the necessary settings for the relevant input
channels and output channels according to the previous section. The routing assignment operation is as
follows: (The mixer also allows the sending method to be used for volume distribution, see section
2.1.3 for details)
[Step 1]: If you are not in the home page, click to return to the home page.
[Step 2]: Click the bus area on the left side of the APP screen to select the output bus that needs to be
routed. Or click the button on the panel
to make the mixer in the routing setting state. At this time, the input channel for routing
assignment is allowed. The fader
slider
is displayed in brown, and the TFT guide screen is
also displayed in brown. The color of channels that cannot be routed is not changed.
[Step 3]: Use the navigation bar
01
to select the group where the input channel is
located, or click the fader page button on the panel (as shown in the right figure),
cancel the [Mute] of the corresponding input channel in the input channel page, click
the button
09
to select the signal from Pre-fader or Post-fader and other locations,
and set the channel routing volume
07
to the appropriate position (as shown below)
01 In the navigation bar, click the index page or the
fader page button to switch to the page where the
channel is located. The small bright spot in the
figure is the gain position indication of the channel.
02 System setup button, click to enter the system
parameter control page. Same function as the
button
on the panel.
03 Scene button, click to enter scene control page, save
or load the scene parameters you need.
04 The pan and balance of this channel assigned to
Main L / R.
03 02 01
04
05
06
07
08
09
10
11 12