Beta Three TQ-22, Справочное руководство

Страница: 24 / 64

-16-
UG-TQ22-EN (V2.2-211226)
TQ-22
Mixer Reference
manual
2.1.6 Compressor
The Compressor controls the dynamic range of the signal when the signal exceeds the set
threshold.
01 In the navigation bar, click the index page or the fader
page button to switch to the page where the channel is
located. The small bright spot in the figure is the gain
position indication of the channel.
02 System setup button, click to enter the system
parameter control page. Same function as the
button
on the panel.
03 Scene button, click to enter scene control page, save
or load the scene parameters you need. It has the same
function as the
button on the panel.
04 Home button, click to return to the channel home
page.
06 Click to switch to the noise gate control page.
05 Click to switch to the PEQ control page. 08 Click to switch to the copy control page.
07 Click to switch to the compressor control page. 10 Click to switch to the channel setting page.
09 Click to switch to the parameter preset page. 12 Threshold, which sets the starting point for the
limiter to start attenuating the signal level.
11 Click to switch to the channel overview page.
13 Reset the parameters to their initial values. 14 Which changes the output level of the
Compressor.
15 Inflection point hardness selection. 16 Input signal level meter.
17 Compressor switch. Lit means the compressor is on. 18 Compressor illustrated. After the compressor is
activated, its working track turns yellow.
19 Start-up time, adjusts the response speed of the limiter
when the signal exceeds the threshold.
20 Release time, adjust the response speed of the
Compressor to stop the limit.
21 Sets the ratio of the input level to the output level
when the signal exceeds the threshold.
22 Level meter, gain attenuation (Red) indicates
how much the compressor attenuates the signal.
23 Current channel master control board, adjustable gain and mute.
03 02 01
04
06
07
08
09
10
11
23
05
19 13 12 18 15 16 21 20 22 17 14