Bestway field-pro IV 1600, Руководство оператора

Страница: 57 / 96

E10
NOTE:
2. Loosen the (6) 3/4" x 3" mounting bolts that clamp the clamping plates to the axle.
3. Loosen the (2) 3/4" x 3-1/2" vertical adjustment bolts on the underside of the axle tube.
Do not remove the clamping plate that secures the axle
stub in position. Loosen the mounting bolts only enough
to allow the axle stub to move freely.
4. Adjust axle tread width as required by axle width configuration.
5. Tighten vertical adjustment bolts so that top of axle stub is snug against the stops on the top
of the center axle tube. Do not torque these two bolts.
6. Tighten all clamping plate bolts. Torque these six bolts to 265 ft-lbs.
7. Repeat the process on the opposite wheel, making sure the measurement is equal on both sides.
Preparation For Storage
1. Always store the sprayer inside a building if possible. This protects vulnerable components
like hoses, fittings, tires, valves and electronic relays from harmful ultraviolet rays, rain, snow and ice.
2. Thoroughly wash and flush the tank and plumbing system with a detergent solution; then
rinse with clean water. Be sure to dispose of all rinse in a safe and careful manner.
3. Clean all exterior surfaces of the sprayer using clean water and detergent.
4. Touch up all metal surfaces where paint has been scratched or damaged to prevent rust.
5. Lubricate and grease all lubrication points.
6. Hand wash all nozzles, strainers and check caps. Install new diaphragms in the check caps
and reinstall on the nozzle bodies.
7. Drain the foam marker tank by removing the strainer bowl. Clean and replace bowl.