BestWater 20210015, Руководство пользователя

Страница: 45 / 70

45
EN
JUNGBRUNNEN 25-00
Setting Up and Connecting
Drain drilling Frontview
(with marks)
1. 2.
3.
Drainclamp install Sideview
Foam rubber gasket
( 7 mm Ø hole)
Drainclamp 40 mm Ø
( 1/4“ plug-in connector)
Screw
Mother
Drain-hose 1/4“
Plug-in connector 1/4“
Drainclamp installed Frontview
(with installed Drain-hose)
The drain
The drain of the BestWater system can
be applied to all 40 - 50 mm thick plastic
hoses with ease.
Figure out where you will set up the drain
clamp before installation.
Note that the water drain should be vi-
sible once completely installed.
After you have determined where the
drain clamp will be installed, drill a hole
above the air trap with a 7 mm drill bit .
Remove the residue after drilling.
Fasten the
clamp to the trap .
Turn the screws equally among the
drain installation kit .
No additional fittings (depressurisers,
check valves, etc.) may be installed on
the hose to the drain clamp .