PowerBoard
®
NX – Installation Instructions
Rev. G 0713
75638 / 75643 pg. 13
This device complies with Industry Canada licence-
exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not
cause interference, and (2) this device must accept
any interference, including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR
d’Industrie Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux
deus conditions suivantes: (1) l’appareil ne doit pas
produire de briuillage, et (2) l’utilisateur de l’appareil
doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful
interference
and
(2) This device must accept any interference
received, including interference that may
cause undesired operation.
The user is cautioned that changes or
modifi cations not expressly approved
by the party responsible for compliance
could void the user’s authority to
operate this equipment.
Battery Replacement
Battery
Each sensor is powered by a CR2450 3 volt bat-
tery that may periodically need to be replaced.
1. Remove the PowerBoard
®
wire harness fuse
that is next to the car battery.
2. Remove the two screws and the cover plate on
the sensor. Slide out the circuit board and note
the orientation of the board. Replace the bat-
tery and slide the board back into the housing
with its original orientation. Leave the vehicle
door or doors open.
3. Reinstall the PowerBoard
®
fuse and wait 30
seconds. The sensor is reprogramming its ad-
dress during this time.
4. Shut the door(s). Open and close the doors(s)
to check for normal operation.
If opening a door fails to operate the Power-
Board, open the appropriate door and remove
the PowerBoard
®
fuse. Wait 30 seconds and
the reprogramming will repeat. Reinstall the
fuse and check for normal operation.
