Using the #M8-1.25x20mm Button Head
Screw and the #M8-1.25 Hex Nut,
attach the supplied drilling template
#523.18 to the body flange, centering the
slotted template hole over the pre-existing
slotted hole in the welded body flange,
toward the rear fender.
Mark the position of the middle hole in the
template on the welded body flange.
Driver side shown.
1 Drill a 1/8” hole in the welded body flange,
using the middle hole of the drilling template.
2 Remove the template, and drill out the
1/8” hole to 3/8”.
Driver side shown. Repeat this process on the
passenger side of the vehicle.
P10 - 75152 Rev. C 0416
Installation Instructions - PowerBoard
®
© 2016 Bestop, Inc.
Page 10
Section 7
Drill Holes for Motor Linkage Mounting
Step 2
Step 1
Step 1
Hardware
Step 2
2
1
1/8” Drill
3/8” Drill
Drill a 1/8” hole
using the template
Remove the template
and drill out the 1/8”
hole to 3/8”
Drill Template
Part #523.18
Qty.1
#M8-1.25
Hex Nut
Part #473.84
Qty.1
#M8-1.25x20
Button Head Screw
Part #473.83
Qty.1
