4
READ FOLLOWING NOTIFICATIONS WITH CARE
BEFORE YOU USE THE WELDING POSITIONER!!
BE CAUTIOUS AND COMPLY WITH GENERAL INSTRUCTIONS GIVEN ON
LIFTING WORKING!!
THE WORKPIECE MUST BE ELECTRICALLY GROUNDED. ALLWAYS USE
THE MACHINE`S OWN ELECTRICAL GROUND CONNECTION AND
FURTHER GROUND-CONNECT DIRECTLY TO THE WORKPIECE, IF
WELDING CURRENT EXCEEDS 500 AMPERES OR THE PIECE IS LARGE.
USE GROUND
CAPLE 70-95 (ABI-
CM 70-95 OR
EQUIVALENT) TO
THE MACHINE`S
OWN GROUND
CONNECTION
CHECK THE SUFFICIENT GROUND CONNECTION OF THE WORKPIECE
BEFORE BEGINNING TO WELD. THE MANUFACTURER IS NOT
RESPONSIBLE FROM CONSEQUENCES RESULTING FROM AN ABSENCE
OF GROUND CONNECTION NOR INSUFFICIENT OR INCORRECT GROUND
CONNECTION.
THE WELDED WORKPIECE MUST NOT TRANSFER HEAT TO THE TABLE
PLATE. THIS IS TO PREVENT DAMAGES FROM OCCURRING TO THE
MACHINE BEARING DUE TO THE THERMAL EXPANSION.
WELDING DIRECTLY TO THE TABLEP LATE IS STRICTLY PROHIBITED!
THE WELDING POSITIONER MUST BE CONNECTED TO A PLUG THAT
CONTAINS RESIDUAL-CURRENT DEVICE!
COMPLY WITH USER MANUAL AND LOAD CHART WITHIN THE MACHINE.
CAREFULLY GET TO KNOW THE LOAD CALCULATION PRACTICES.
