No Diving or Jumping.
Observe all Safety Rules.
i. Place a top connector (key 4)
over the top edge of the pool
wall (key 5) with the tab on
the outside of the pool. Line
up the hole in the tab with the
screw hole near the top of the
vertical column. The tab must
be on the
outside
of the verti-
cal column. Make sure the
vertical column is straight up and down.
j. Slide one end of a top rail (key 6) into the top connector.
k. Fasten the top connector to the vertical column with one self-
tapping screw (key 3).
l. Repeat the steps (i to k) for the rest of the top rails.
m.Line up a resin top connector (key 18) over the
buttress top plate (key 17). Hook the resin top
connector under the inside edges of the top rails
(key 6) and hold the hooks firmly in place. Bring
the connector down into place under the top
rails as shown in diagrams 24 and 25.
n. Line up the screw hole in the resin top connec-
tor (key 18) with the hole in the upright. Fasten
the connector in place with a one inch self
tapping screw (key 19). Tighten the screw.
o. Repeat steps (m and n) for the remaining resin
top connectors.
p. Make the pool settle into a
perfect circle by pushing the
top of the pool wall
vigorously
inward at each vertical (this
will help make the bottom of
the pool wall shift into a
perfect circle).
2-9
Push vigorously
Push vigorously
26
Important:
One or more of the
followinghardware
bags has arrived
with your pool:
Part Nos. 1184309
and 1184310.
These contain
longer, 1" (25mm)
self-tapping
screws which
are
only
used in the
hole shown in
diagram 25.
18
24
18
6
6
17
25
18
19
23
4
1
6
5
3
