No Diving or Jumping.
Observe all Safety Rules.
c. After the pool wall has been installed, reconfirm distances to the
base plates.
Make sure
the round ends of the pool have been prop-
erly located or the pool wall will not be symmetrical.
When you come to Section 3, Part A, replace Step 1(d) with the following:
1. Set the Pool Wall in place
d. The slotted tubes are colour coded or stamped with a part number.
Use the chart below to choose the types and quantities of slotted
tubes for your pool (part nos. are shown in brackets under each
colour). Set lengths of slotted tube onto the top edge of the wall as
you uncoil it and join the slotted tubes with connectors as you go,
leaving a 1/2" (13 mm) gap between each. (If you have a
beaded
pool liner
, set lengths of
liner retainer
on the top edge of the wall
first, then the slotted tubes and connectors.)
Pool Size
Quantity and Colour Code (with part nos.)
Buttress Tube Transition Tube A Transition Tube B End Tube
12' x 18'
n/a
4 blue
n/a
6 plain
(no. 1470127)
(no. 1470126)
12’ x 24’
4 white
4 Black
n/a
6 plain
(no. 1470105)
(no. 1470129)
(no. 1470126)
15’ x 24’
2 white
4 green
n/a
8 plain
(no. 1470105)
(no. 1470100)
(no. 1470097)
15’ x 30’
4 green
4 green
n/a
8 plain
(no. 1470100)
(no. 1470100)
(no. 1470097)
18’ x 33’
4 green
4 green
4 green
6 plain
(no. 1470100)
(no. 1470100)
(no. 1470100)
(no. 1470098)
(n/a = not applicable; plain = no colour code)
When you come to
Section 3, STEP 6
, insert the following extra steps 2(f), (g)
and (h) after step 2(e):
The 18 x 33
pool is the
only size
that uses
all four
types of
slotted
tubes.
Diagram
18 shows
the loca-
tions for
each type.
2-5
Slotted end
tubes
Buttresses
Transition B slotted
tube
Transition A
slotted tube
Transition B
slotted tube
Transition A
slotted tube
Buttress
slotted tubes
15
!
Hint:
Using a 2" (5 cm)
piece of duct tape,
the ends of the 6"
(15 cm) metal
slotted tube con-
nector over the
slotted tubes and
onto the pool wall.
This will prevent
the slotted tubes
from moving
during liner instal-
lation.
!
Hint:
Use duct tape at
the top of each
buttress to tempo-
rarily hold the pool
wall from falling in
before it is prop-
erly fastened in
place.
!
Hint:
Secure the slotted
tube connector to
the wall with a piece
of duct tape after
installation to pre-
vent it from lifting off
the wall.
