No Diving or Jumping.
Observe all Safety Rules.
15
10
42
39
40
41
15
26
16
9
9
9
21
10
37
Caution:
Failure to properly
install and tighten
all of the bolts and
nuts may void the
warranty on your
pool.
1/16"
(2 mm) gap
1/16"
(2 mm) gap
38
1-16
!
Important:
Ensure all four
tabs at the end of
the diagonal are
inserted into the
slots in the upright.
c. Fasten one upright (key 9) to
the base plate using three 3/4"
long bolts (key 21) and nuts
(key 10). Make sure the bot-
tom end of the upright is
fastened to the base plate.
The bottom end of the upright
has three large holes which
are used to fasten to the base
plate.
d. When you come to section 2, you will install the
base rails, linking them to the buttresses. Make
sure now that there is approximately a 1/16" (2
mm) gap under the tab at the bottom of each
upright so the bottom rails slide on easily.
e. Repeat steps (a) to (d) for the other side of the
pool.
9. Install the Diagonals
a. Hold one
diagonal
brace (key
15) ap-
proxi-
mately
horizontal,
insert the
four tabs at
the end of
the diagonal into the slots in
the upright (key 9) (see dia-
gram 39).
b. Pull upward on the inserted
end of the diagonal to make
the tabs slide up and lock into
position in the slots. At the
same time, swing the other
end of the diagonal down
onto the diagonal bracket
(key 16) on the base channel
(see diagrams 40 and 41).
