Besam SW200i, Инструкция по установке и обслуживанию

Страница: 72 / 82

16.1 Error indication
• During normal operation the ERROR LED on the control unit is illuminated.
• An extinguished LED indicates that there is no electrical power power.
• A flashing light on the LED indicates that the operator is out of function (see table below).
• An audible warning signal can be achieved by using the accessory board AIU. It is connected to
the 24 VDC and plugged into the EXU-SA relay output terminal.
Remedy Reason LED flash frequency
Make a kill reset, reset kill switch or reset fire alarm Kill impulse is active One 0.3 s flash, 10 s pause
etc.
Check for short circuit + 24 V DC external error One 0.3 s flash, 2 s pause etc.
Check for broken monitored sensor Sensor monitoring error One 0.3 s flash, 2 s pause etc.
Replace control unit Control unit defective Three 0.3 s flashes, pause etc.
Check the encoder cable. Encoder error Four 0.3 s flashes, pause etc.
Open and close the door manually and thereafter
check the automatic function. If the operator is
still out of function replace the drive unit.
Check for e.g. short circuit in the locking device Locking device defective Five 0.3 s flashes, pause etc.
Replace locking device
Replace EXU-SI board EXU-SI board defective
Connect the sync cable Sync cable not connected or
defective (double door only) Six 0.3 s flashes, pause etc.
Replace the sync cable
Check the flash frequency on the SLAVE LED and
take necessary measures in accordance with this
table. SLAVE control unit defective
(double door only) Seven 0.3 s flashes, pause etc.
Wait for the motor to cool down Motor overheated Eight 0.3 s flashes, pause etc.
Toggle impulse Blocked door and constant
impulse. Nine 0.3 s flashes, pause etc.
Check set up. Settings have been made that
requires a new learn or the
learn has failed. Ten flashes
Make a new learn.
1009937-EI-1.0 Issue 2013-02-10 72
16 Troubleshooting