Besam SW200i, Инструкция по установке и обслуживанию

Страница: 54 / 82

12.3.2 Arm system selection
Factory set arm configuration is PUSH 8 1/4" (210 mm), if other is required:
Select arm configuration on the DIP-switches according to the table below.
ON=1 OFF=0
Spindle location (hinge to outgoing spindle) Type of arm system
AS 4
DIP 8
AS 3
DIP 7
AS 2
DIP 6
AS 1
DIP 5
0 0 0 0 PUSH, 8 1/4" (210 mm) Pushing
0 0 0 1 PUSH, 3 3/4" (95 mm) Pushing
0 0 1 0 PUSH, 2 3/4" (70 mm) Pushing
0 0 1 1
0 1 0 0
0 1 0 1
0 1 1 0
0 1 1 1 Concealed (Outswing)
1 0 0 0 PULL, 8 1/4" (210 mm) Reveal 0" - 2 9/16" (0-65 mm) Pulling PULL
1 0 0 1 PULL, 8 1/4" (210 mm) Reveal 2 9/16" - 5 1/8" (65-130 mm) Pulling PULL
1 0 1 0 PULL, 3 3/4" (95 mm) Reveal 0" - 2 9/16" (0-65 mm)
PULL, 2 3/4" (70 mm) Reveal 0" - 2 9/16" (0-65 mm) Pulling PULL/PAS
1 0 1 1 PULL, 3 3/4" (95 mm) Reveal 2 9/16" - 5 1/8" (65-130 mm)
PULL, 2 3/4" (70 mm) Reveal 2 9/16" - 5 1/8" (65-130 mm) Pulling PULL/PAS
1 1 0 0
1 1 0 1 PULL 210, 8 1/4" (210 mm)
Distance ( Door thi hinge) = 75-130 mm Sliding push
1 1 1 0 PULL 95, 3 3/4" (95 mm)
Distance ( Door thi hinge) = 0-80 mm Sliding push/Offset pivot
1 1 1 1 - Concealed (Inswing)
Note! The Panic Break Out Switch, shall be a normally closed contact, and is only needed at the
Concealed inswing application.
Note! After changing any system selection a new LEARN must be carried out.
1009937-EI-1.0 Issue 2013-02-10 54
12 Electrical connection